The airbag control module in a 2002 Saturn SC2Êis located underneath the center console. It is the yellow connector behind the shifter.
in the dash above the glove box
above the radio under the center panel
you will have to remove the dash bord
How do you remove a starter on a 2002 Saturn Vue?
In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.
My 2002 Saturn L300 was doing this also, it was the BCM (Body Control Module). Cost about $600 to fix at the dealership
Avalon 2002 air bag module location?
The 2002 Acura airbag control module is located on the firewall in the engine compartment. The airbag control module will be on the drivers side of the firewall.
The air bag module on a 2002 Saturn L330 is located under the center floor console. The sensors are also located under the center console.
Passlock sensor (Ignition housing) Or body control module fault
"Go to module master.com"
both the 3100 and 3800 series engines have the ignition control module mounted under the coil packs. remove the coil packs and there it is.
My Saturn is a L100. I found the fuse in the engine compartment fuse box labeled BCM2 (body control module 2). Good luck!!
How to remove the wiper motor on a 2002 Saturn sc1
Under ignition coils
Powertrain Control Module
It is inside the driver side fender. You need to remove the fender liner to access.
It is class 2 short to ground. It is usually caused by a failing ignition switch or body control module.
The TCM (transmission control module) is located in front of the left front tire. Remove the fender liner to access.
It is located inside the driver side wheel well, you must remove the plastic to see the unit.
First of all disconnect the battery before starting with the other steps. After this remove the lower steering column and the knee blocker reinforcement to be able to access the cables connecting the Body Control Module. Remove the two wire connectors which are located at the bottom of the module then unscrew the bolts that are holding the junction block to the mounting bracket of the dash panel. After this was done, remove the junction block itself and remove the screws that are holding the module to the junction block. Next slide the Body Control Module downwards out of the junction block. This will disengage the guide studs on the block. To install a new BCM module, do the above steps in the reverse order.
Between the transmission and radiator.
PCM ( Powertrain Control Module )
No, it will not.