Want this question answered?
My left rear brake is dragging all time.this is a 1428 4wheel drive year 1997
Drain the brake fluid from the brake master cylinder reservoir. Remove the wiring harness from the brake cylinder. Remove the brake lines. Remove the brake cylinder retaining nuts. Reverse the process to install the new master brake cylinder.
The reservoir is located on the master cylinder in a Mazda 626. To add fluid, simply remove the reservoir cap and pour fluid in.
To refill the brake fluid for a 1992 Acura, you need to remove the cap on the brake fluid reservoir. Add fluid until the dipstick measures full, or the line on the reservoir that says 'full' is touched by the brake fluid.
To fill the brake fluid in a 2001 Honda Odyssey, you need to find the brake fluid reservoir and remove the cap. Fill the reservoir with the right amount of fluid and put the cap back on.
The first thing you should do is remove the master cylinder so you can dump the brake fluid reservoir out. If you have used the brakes, it is a very good idea to get the entire brake system bled and replace all the brake fluid.
no
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
where is the brake fluid reservoir on a 2006 jetta
Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.
On the drivers side of the vehicle, remove plastic vent screen at bottom of windshield. Using a regular screwdriver,to remove the plastic screws. Under it you will find a yellow capped reservoir this is you brake fluid reservoir. Insure you put correct brake fluid. The cap has minimum specifications as to what kind to use.
The way to check the level of your brake fluid is to remove the cap on the brake fluid reservoir and read the dipstick. There may also just be a line on the reservoir that says 'Full.' If your brake fluid does not reach that level, add type DOT 3 brake fluid.