0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you pull the camshaft gear off a 305 Chevy?
If you are asking about the sprocket bolted to the front of the cam, you would need to remove the timing cover and remove the 3 bolts on the front of the sprocket. If you are asking about the gear on the back that drives the distributor, it is integral and cannot be pulled.
What is a cam sprocket?
A cam sprocket is a part which is attached to one end of a cam shaft in an engine. A cam sprocket, along with the timing belt maintain the timing between the camshaft and crankshaft, which ensures that the engine runs properly.
What is a crank gear?
The sprocket on the nose of the crankshaft that drives the cam sprocket.
How do you adjust cam chain on TTR 125?
The way to adjust cam chain on TTR 125 is by putting the chain on the cam sprocket and making sure that it is the same. You can also remove and reset it as well.
What are the valve timing settings for a 1990 Galant 2.0L?
If its a single cam engine the top dead center marks will be on the crank sprocket and the oil pump housing. (notches facing upward) and on the cam sprocket the notch is on the cam cover. You musnt remove it when timing the engine sprockets. . On DUAL cam 2.0 the intake and exhaust cams have 2 marks. the intake (rear sprocket) will have a notch facing up and one toward the front of the car. The exhaust cam sprocket(front one) will have a mark facing upward and the other aligning with the intake one but it will be facing rear. They must be pointing towards each other. the crank sprocket is the same as the single cam alingment.
What hold the cam in on a350 Chevy?
The cam is held by the 3 bolts that holds the cam gear on the block in order to remove the cam shaft you have to remove the distribitor & intake & loosen up your rocker arms & remove the push rods &lifters.
Where are the timing marks on a 96 S10 22 cam sprocket?
Look closly at the sprocket and you will see a small dot or indentation,you align both dots (cam and crank sprocket dots)
How do you remove cam chain tensioner on a xr250 Honda?
You will need to remove the clyinder head to gain access to the tensioner and guide, they should then lift out Hope this helps Andy Do you remove the top cam chain sprocket or does tensioner come out another way
What does the cam sprocket line up with when putting on a timing chain?
Generally, for most single cam engines, there is a dot or mark on the cam sprocket and a similar mark on the crank sprocket. Point them at each other. the timing marks on the crank and cam sprockets must be lined up with marks on the timing chain in an overhead cam engine
Does a vw bora v5 have a cam belt?
The bora v5 does not have a cam belt. It has two timing chains. The first is driven by a sprocket on the crankshaft. This first chain drives a sprocket connected to a smaller sprocket on a common shaft. This smaller sprocket drives the camshaft chain which drives the twin cam shafts. Both chains have tensioners.
What is head torque on a ATV 89 350 Yamaha warrior?
If they are the M8 Allen bolts 14 ft lb ,,,,,,,, M10 Flange bolts 29 ft lbs .The side bolts at 7.2 ft lbs .The cam sprocket bolt at 43 ft lb .
How do you change a camshaft on 1998 ford escort?
Take off the intake duct and the valve cover. Remove the drive belt. Remove the rocker arms and lifters. Keep track of their positiion as they must go back in the same position. Remove the coil pack. Remove the timing belt Remove the sprocket bolt and then remove the cam sprocket. Remove the camshaft from the transaxle end of the head.
