Want this question answered?
Remove the decorative cover to the window switch panel. Remove the window switch retaining screws. Remove the wiring harness from the back of the window switch. Reverse the process to install the new window switch.
On a 1995 Chevrolet Caprice your door panel and window switch are two different parts. To remove the door panel you remove the 8 screws along the outer edge of the door and then pull the panel off. to take the switch off there are 4 more screws on the back of the panel you remove
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
Pop the door panel off. Remove screws including the one behind the window switch. Then, lift up on the panel. You will see where the window switch plugs in.
Remove the door panel and you will see the window regulator. There should be two or three bolts holding the door panel on, pop the window switch out and use a long flathead screwdriver to pop the panel out of the calmps securing it to the door
Remove switch panel and jump wires on switch- if this works bad switch Remove door panel and see if the motor is getting power-if it is getting power, bad motor
Pop out the switch panel and remove the two screws disconnect the wiring and reinstall the new switch
You can find the window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
There are 10 Phillips screws holding the door panel on. First you would need to remove those. Then you can remove the door panel from the door. On the backside of the door panel you would need to remove the plugs from the backside of the switches. Then you can remove the screws that hold the switch into place on the door panel.
First prise up and remove the door armrest to the rear of the window switch and then prise up the complete window switch panel (including padded area) FRONT EDGE FIRST. Continue to lift and prise from the front edge until the panel can be pulled forward so the tab on the rear edge can slide out from under the armrest frame.
remove the door panel then remove the switch which is secured at one closest to the front end by a Philips screw into a gold retainer
The 1994 Chevrolet Camaro power window relay switch can be found inside of the driver side door. You will need to remove the door panel to access the power window relay switch.