Want this question answered?
Door handle to what?
How change door handle,drive side jetta 97
Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
there are screws in the door, and holding the handle on. You can get to the ones holding on the handle by pulling off the covers on each side of the door handle inside.
yes remove door panel drill rivets replace with new door handel from gm dealership
you have to remove the inside door panel to get to the nuts on the back of the handle housing. then you have to undo the door latch actuator rod from the handle (it's little yellow colored plastic snap lock at the end of the rod).
You need bushings in the bottom door hinge. You might have to remove the finder to get to it. You might trying to go to a you pull it and find a good hinge from a 89 to 97 Thunderbird or Cougar. It would be less work.
how do you get the door open
You don't remove the inner door panel, it's a stamped single piece, however the outer door panel is removed by:Disconnect the door handle by lifting it then press the retaining pins out. Examine the handle at the base, where it connects in to the door. The small pins press out easily using a small rod with a flat surface.After the door handle has been removed, open the door and remove all of the screws around the perimeter of the door skin.You can access any of the internal components of the door from the outside.
remove the screws that are around the side and bottom of panel. remove covers located by mirror and by the door hinge. remove the screws you found use a small bent screw driver and put it in the hole on the underside of the the close handle to push the cover off the handle. remove these two screws remove the screw behind the door open handle. pop off the cover that is over the mirror mechinism. now pull up on the panel and voila!
with a screw driver
no