you have to remove the inside door panel to get to the nuts on the back of the handle housing. then you have to undo the door latch actuator rod from the handle (it's little yellow colored plastic snap lock at the end of the rod).
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
You have to:Remove the door panel.Undo the rods off of the handle.unbolt the door handle from the inside of the door.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
Remove the inside door panel of your 1994 Chevy Lumina. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
take inside door panel off and unbolt outside door handle from the inside.
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
you have to remove the lock clinder
It all depends on the vehicle that you are working on.
Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
You have to remove the inside door panel to get access to the door handle nuts.
Remove inner door panel for access