theres some plastic clips all around the door but you have to remove three screws one on the door handle one behind the reflector on the door and one behind the door handle then you have to wiggle the panel free you will here some noise you have to pry it off try not to break the clips that is not easy to do i broke some the panel still attaches
In order to replace the drivers side mirror on a Buick Rendezvous, you will need to remove the door panel. You will have to disconnect the electrical connector and you will be able to remove the mirror and place the new one on.
how do you remove left rear door panel on a 2008 buick lucerne cxs.
Remove door panel, then three bolts on mirror inside the speaker housing area.
Take your door panel off and replace them...
Remove the door panel.
Using a screw driver, remove the screws and the clips that are in the door panel. Gently pull the door panel away from the frame, remove any wire connectors and the door panel should be free.
remove screw holding the trim around the door handle. remove trim piece around the door handle. pop out the clear red plastic piece and remove the bolt behind it. there is one more bolt, im pretty sure under the door handle. the rest of the door panel is held on by pushin style clips. remember to disconnect the wiring harnesses
there is 3 bolts holding the panel one is behind the red reflactor,the other is behind the door pull and the other is on the door open handle itself,the use a 10mm and a Philips screwdriver the panel has to be carefully pulled away fronm door as it has the plastic tabs holding it if your careful this is an easy job
I have to replace the drivers side door handle on a 2006 Buick Lucerne. How do I remove the panel to access the bolts on the handle. (Like most panels there isn't visible screws to remove the panel.
You have to remove the door panel...not easy, but do-able. Once that is off you can remove the door handle and replace it.
Unscrew it
Very Carefully