Want this question answered?
how do you remove door panel on 2007 ford escape
can youi show me how to pop off the panel to remove the radio in the 2007 dodge ram.
magic
Remove the two vertical Phillips head screws in the grab handle. Remove the window handle if equipped. Remove/ unplug the electric mirror/ window switches if equipped. Grab the doors at the bottom and pull hard. Then work you way around the left and right side of the door panel pulling on the panel. There are some white plastic push pins on the back of the panel that hold it to the door. When all of the pins are loose, lift the panel upwards and remove it. This is a less than 5 minute job.
Using a screw driver, remove all the screws and clips from the panel, and gently pull the panel away from the frame. Remove any wiring connectors between the panel and frame, then pull the panel off the rest of the way.
Use a screwdriver, and remove the screws and clips in the door panel. Pull the panel out slowly from the frame, and remove the wire connections, and the panel will fall free.
2004 Ford F150 Remove Front Door Panel and Mirrors2004, 2005, 2006, 2007, 2008, Ford F150 Door Panel and MirrorsFor the 2004 - 2008 - this is the best I found anywhere for removing front doors and the miirrors. It has clear pictures. Took the panel off if 15 minutes or less once I found this.http://www.kwmuth.com/techsupport/pdfs/21000960.pdf
The 2007 Ford Sport Trac inside door panel is held in place by six retaining clips. Pry outward on each retaining clip to remove the door panel.
No
take it to a body shop
In the front passenger footwell by the kick panel ( the kick panel is the interior trim panel just in front of the front doors by a persons feet )
Easy as falling off a log: There are four Phillips screws around the edge of the panel. Undo them. There is a Phillips screw in the door pull (dish) remove that, then prise the winder handle(back door panels only). Now prise the left, right and bottom of the panel away from the door about an inch or so. Now grasp the left and right sides of the panel and lift it clear of the lip at the top. The handle will be able to be pushed through the panel slot. Job done.