you will see little things that look like dings on the door fram drill and re-rivet
To install a new window motor in a Ford Sport Trac, first, disconnect the vehicle's battery to ensure safety. Remove the door panel by unscrewing any fasteners and gently prying it off to access the window motor. Disconnect the old motor's electrical connector, unbolt it from the regulator, and then install the new motor by reversing the process—attach it to the regulator, reconnect the electrical plug, and reassemble the door panel. Finally, reconnect the battery and test the window to ensure proper operation.
Remove the door panel. Remove the bolt that fastens the regulator to the window. Remove the 3 bolts that hold the regulator assembly to the door. Squeeze the entire assembly through the largest hole and replace with a new assembly in reverse order.
The question is: Is this the drivers window switch but it opens the passenger side's window? Who was driving or in the driver's seat. You may have spilled enough beer on the arm rest that leaked into the switch and created a corrosive electrical connection for the window motor/
you have to remove the 2 brackets of the rear panel situated where the rear window close, then take the rear panel up, that's all
How to replace the rear window motor on a 2001 Sport Trac: 1. fold down the rear seats. 2. flip up and remove the spring-loaded hinge on the cargo platform by removing the philips-headed screws. 3. remove the plastic fasteners for the rear plastic body panel. 4. pry the plastic rear body panel from the tabs at the top (left and right). 5. remove the two plastic felt fasteners. 6. peel down the motor cover located behind the rear right seat. 7. remove the 3 torx bolts on the motor. 8. using a large screwdriver or small pry bar, pry the motor away from the cable spool, leaving the spool intact on its mount. 9. unplug the motor and remove. 10. using a screwdriver, rotate the spool to give it some play (the window should move some). 11. put a dab of grease on the motor hub. 12. install the new motor by aligning the hub splines and rotating the motor into position. tighten the torx bolts. 13. Reassemble everything. 14. Initialize the new motor: open door, turn key to 'on', push rear window button 6 times, turn key to 'off', push rear window button 6 times, turn button right until window closes all the way, turn button left until window opens all the way.
If only the window on a 2000 Montero Sport is not working, the issue could be related to a faulty window switch, a blown fuse, or a malfunctioning window motor. First, check the fuse related to the windows to see if it needs replacement. If the fuse is fine, test the window switch and wiring for any defects. If those components are functioning, the window motor may need to be replaced.
Dealer? Salvage Yard?
Could be bad switch? Bad motor? Broken wire in door hinge area Check to see if you are getting power to motor If you are motor is defective If not check out other mentioned areas
if the motor is turning then it could be off the track or a gear might be stripped.
Begin by removing the wiring harness from your 2002 Montero blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
the window motor could be busted or a fuse could have blown.
To remove the quarter panel window on a 1999 Mitsubishi Montero Sport, first, you'll need to carefully pry off the interior trim panel surrounding the window. Once the trim is removed, locate and remove any screws or bolts securing the window to the frame. Next, carefully cut through the adhesive sealant using a utility knife or a window removal tool, and gently push the window out from the outside. Be cautious to avoid breaking the glass during the removal process.