0
Remove the bolts that hold the drive shaft on to the universal joint on each end.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you remove a you-joint on a 1996 Chevy s10 blazer?
or you talking about the driveshaft u-joint?
How do you remove the top 2 bell housing bolts on a 1996 Chevy S10?
Once you have the driveshaft off and the crossmember out the engine-tranmission assembly will pivot enough in the motor mounts to let you get at them.
Can you flat tow 1998 s10 2wd auto trans?
You'll have to remove the driveshaft first.
How do you remove the driveshaft from a 1999 Chevy s10 pickup?
Make sure truck is level or pointing downhill is even better. Remove the 4 bolts at the differential. Pry the driveshaft forward. Slide the front out of the transmission. Hold the front most piece with your hand as it comes out of the transmission. At re-assembly torque the bolts to 15 ft/lbs.
How to drop 2000 s10 driveshaft to down on dolly?
What I believe your trying to ask is how to remove the drive shaft? If so than all you need is to remove the
How do you remove bench seat in 1996 Chevy S10?
Remove the bolts from each corner.
What is the difference between an S10 and a Chevy S10?
An S10 is the same as a Chevy S10.
How to remove 92 Chevy s10 2wd v6 4.3l rear driveshaft won't just slide off as manual says?
very carefully, sometimes the universal joint need a little persuasion to separate from the pinion flange after you have removed the clamps.
How do you remove a driver seat to a 1991 Chevy s10?
Unbolt it from inside, lift it out.
How do you remove the clutch cable on a 1996 Chevy s10?
There is no cable, it is hydraulic operated.
How do you replace a rear seal on the drive shaft of a 1988 Chevy S10 pickup?
The driveshaft unbolts from the diff at the rear. If you haven't found this out maybe its best to take it to a garage.
Do you have to remove the dash to replace the heater core in a 1994 Chevy S10 pickup?
Yes.
