I just did it. You do NOT need to remove steering wheel.
1. remove the screws that hold the plastic cover around the steering wheel and key tumbler.
2. Remove the top and bottom plastic pieces.
3. Using a "Z" type phillips or an "L" shaped phillips screwdriver, unscrew the single phillips screw at the top of the switch.
If you think that you will strip it, use a long flathead screwdriver and leverage it to the back of the phillips to keep the presser while unscrewing.
The entire process takes less than 10 minutes.
good luck
i wish .....but no ..not with going to aftermarket ECU.....
Under the front passengers feet
Under the dash next to the ecu. Sitting in the passenger seat, it's where your left foot would rest against the center console.
all ecu codes are posted at mx6.com and probetalk.com
How to remove ecu from a renault clio 2003
how do ecu chips work how do ecu chips work
Under the drivers seat
how do you remove the ecu unit from a vauxhall astra 1.4 sl
Remove bevel cover then glove box. ECU sits directly behind it.
The ECU on a 1993 Cadillac Deville is behind the glove box. To remove the ECU, remove the bolt and pull down the plate.
It's on the front passenger floor board....Disconnect Negative battery terminal. Remove the carpet from the top. Remove the ECU cover. Remove the ECU retaing screws. Disconnect the connector and pull out the ECU..........Installation in reverse.....
The RX8 ECU is installed into the black plastic box on the front, passenger (US) side of the engine bay.