Remove 2 bolts in front on the bottom of the engine cover. Remove 2 Phillips bolts in the ash tray area. and lastly there are two latches toward the back of the cover....one on each side. You then pull the bottom of the engine cover toward the rear and tilt the top out slowly. It's easy.
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
on the 3S-FE engine, you will have to remove the engine from the car, then pull the cover off where the timing belt is. The water pump is inside there. It's a JOB.
If it is a two hole riveted cover
remove rear compartment floor trim remove greenish colored cover screws remove cover remove screws from pump assy and lift out.
This is also known as the gear position switch. It is inside of the rear crankcase cover. You must remove this cover to service it or renew it. The neutral switche is combined with the reverse switch and I am pretty sure you have to remove the engine out of the frame to do this job.
The brain or ecm is located on passenger side, underneath glove box. Remove a few 6mm screws and there it is behind plastic cover.
Answer replacing the heater core on a 1991 explorer is a simple job and takes around 30 minutes. disconnect the hoses from core in engine bay. remove access cover located below the dash on passenger side. remove core, replace core.
The steering wheel cover on a 1991 Honda Civic DX is held on by several mounting screws. Remove all the hardware and the steering covers will just pop off.
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
The engine oil is added by removing the engine oil cap on the passenger side engine valve cover ( it's on the top of a metal extension tube from the valve cover near the front of the engine )
no drainplug on the engine. fan-cooled 2-stroke. it has no dedicated oil sump. to drain the chaincase oil just remove the cover, wipe out all the oil, re-install chaincase cover and fill with new oil.
To change the Spark Plugs on a Previa (1991-1996) you have to remove the passenger front seat, lift the carpet and then you will find a cover on the floorplate that has to be removed. Once the floorplate cover is off you will see the engine. There is also a small cover over the spark plugs and wires that has to be removed. The 2.4 liter petrol engine uses small 16mm spark plugs and a small 16mm socket will be needed to replace the plugs.