Want this question answered?
How do i change the heater core on a 1997 ford e150
Corrosion? Contaminated brake fluid?
The resistor is located to the lower right of the blower motor. You will need to remove the battery to access it
In a 1997 Ford E-150 , 4.2 L , V6 engine : 3 - 6 2 - 5 1 - 4 front of vehicle
In the fuel tank.
on the right side of the engine
Yes, but not a bumper hitch. Install a undercarriage trailer receiver hitch system.
my 1997 e 150 has a 35 gal tank.
" regular " unleaded / 87 octane
Open the rear doors and between the floor and the bumper is a small opening (usually covered for theft reasons and may require a screwdriver or socket to remove). This will give you access to crank the spare tire cable down using the tool for adjusting the scissor jack provided with the vehicle.
g7qQLk bviuxdmkojar
On the rear bumper is a small plastic cap. Remove the cap, insert the flat end of your tire iron into the hole. The flat end will engage a slot about 12-16" inside the hole. Start turning the tire iron, and your spare wheel will be lowered down on a cable from underneath the van.