Want this question answered?
pull it off until its breaks
To remove the front bumper * Remove the front indicators * Raise the front wheels off the ground and support the front of the car with axle stands * Looking under the front of the car you will see a cross-member which supports the front of the engine and the radiator etc. You should see the heads of three bolts at each end of the cross-member. The outer two bolts are the ones securing the front bumper, remove these and the bumper will slide forward and out.
what service kit is needed to service a 2006 citi golf that has 100000 km on the clock
You have to remove the front bumper there are 7 bolts that hold it in place then another 6 near the wheel weld take out just the two top screws that hold the front end in place. Slightly move it to where you can remove the screws to the fan. Replace the fan and put the bumper back together.
you need to remove front bumper to access 8 torx screws 4 hold radiator to front panel and 4 hold air con rad to main radiator it should take about one and a half hours
1300 citi golf cam shaft torque settings
You have to set the belt timing in the VW Citi Golf 1300 without the markings.
The horn is located under the front bumper behind the fog lights. Slide your fingers up under the and remove the 2 clips attaching them then replace it.
depending on year and model but is usually in right hand side of front bumper
Thor footkeer bitrehshoror baitchafoongabuy a propper golf
To remove the headlamp you have to reomve the front bumper, for this you will need a torx 20 and 30 driver and a flat head screw driver. Unclip the front grill, looking down at the bumper on the left and the right there are 2 t30 screws that need to be removed.on the left and the right of the grill there is the same (2x t30) . On the bottom of the bumper, remove the left and right vent , there will be a t30 screw under each, the vents/grills will pop out u may need a flat head screw driver. under the wheel arches there are 4x t20 screws on both sides remove these and the bumper will drop. then simply remove the head lamp 2 t20 screw on the top and 2 at the bottom
Underneath the ashtray