To remove the headlamp you have to reomve the front bumper, for this you will need a torx 20 and 30 driver and a flat head screw driver. Unclip the front grill, looking down at the bumper on the left and the right there are 2 t30 screws that need to be removed.on the left and the right of the grill there is the same (2x t30) . On the bottom of the bumper, remove the left and right vent , there will be a t30 screw under each, the vents/grills will pop out u may need a flat head screw driver. under the wheel arches there are 4x t20 screws on both sides remove these and the bumper will drop. then simply remove the head lamp 2 t20 screw on the top and 2 at the bottom
"http://wiki.answers.com/Q/What_type_of_alternator_is_used_for_volkswagon_mark4_golf_1.4s"
Remove the headlight retaining bolts. The retaining bolts can be access through the engine compartment. Remove the wiring harness. Reverse the process to install the new headlight.
puch the knob on the headlight switch in, then turn it clockwise about a quarter inch, then pull it out. Its actually very easy.
air bag control module fault memory can only be checked and erased with diagnostic equipment
You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
How to remove headlight assembly on 2003 Lexus GX470
# Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now # Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
How do you remove the headlight assembly on a 2001 camaro?"
You must remove the front bumper to access the headlight.
Remove the retaining screws from the headlight assembly. Remove the wiring harness from the back of the headlight. The headlight will come out. Reverse the process to install the new headlight.