answersLogoWhite

0


Best Answer

Remove the front wheel then remove the 2 caliper bracket bolts behind the rotor and the rotor should slide off.

User Avatar

Wiki User

โˆ™ 2012-10-01 04:52:26
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove front rotors on a1999 ford crown Victoria?
Write your answer...
Submit
Related questions

How do you remove front rotors on a 1994 crown Victoria?

With the wheel off, remove the calipers, then the rotors just come off.


Will lighting control module from a1999 Crown Victoria fit a 2004 Crown Victoria?

No


How do you remove the stuts rear from ford crown Victoria 92?

How do you remove the stuts rear from ford crown victoria 92?


What is the oil capacity for a1999 Ford Crown Victoria?

4.6 L engine with filter change should hold 4.5L of oil.


What causes the rear brakes to thump on a 2000 crown Victoria?

Probably scoured rotors.


How do you replace heater core in 2000 crown Victoria?

How to remove the heat core housing on a 2001 crown Victoria? I remove the dashboard, can't get heat core housing out.


How do you remove front rotors 95 ford crown Victoria?

take off a break pads and calipers, take a cap off a rotor then take a pin from a rotor shaft then take a big nut out.Have fun


How do you remove fuel pump from a 1998 crown Victoria?

You have to remove the gas tank. Its in there.


Where is the fuel pump located on 1989 Crown Victoria?

the fuel pump on the crown Victoria is located in the gas tank and if replacing it you have to remove the tank to get to it...Dennis Sison


How do you remove the dash from 1997 Crown Victoria?

hello


How do you remove the rear brake rotors on a 1993 Ford Crown Victoria?

They come off much like the front. With the wheel off, remove the caliper and the rotor just pulls off. The parking brake is in the center of the hub, there fore you do not need to take anything else off.


How do you empty a ashtray in a 1994 crown Victoria ford?

To empty an ashtray in a 1994 Crown Victoria you must remove the ashtray by applying forward pressure.


How do you change an oil pan 1991 ford crown Victoria?

In order to replace the oil pan on the Crown Victoria you have to remove the engine from the car. After the motor has been removed then you remove the bolts holding on the oil pan and it can be replaced.


How to remove front rotor 1996 crown Victoria?

Remove the wheel, remove the caliper, and the rotor will just come off.


How do you remove a door panel on a 1997 crown Victoria?

You can see the blueprint of the door on a 1997 Grand Marquis/Crown Victoria at the related link below. This will aid in the removal of the panel.


How do you remove rear bulb socket on ford crown Victoria?

There are wing nits inside the trunk to remove the housing.


How do you change spark plugs on a 2001 Crown Victoria?

Remove the coil on top of the plug, then just remove the plug.


How do you remove front headlight assembly on Crown Victoria?

What year ? 1993


How do you change the oil pump on 1990 crown Victoria?

Have to remove the oil pan. It's in there.


How do you change oil-pump in 1992 ford crown Victoria?

Have to remove the oil pan to get to it.


How do you change oil pump on a 2002 crown Victoria?

Have to remove the oil pan to get to the pump.


How do you remove the ashtray panel on a 2004 Crown Victoria?

you have to remove the clips on the dash and take out the lock ring around the lighterr


Do you have to have a special tool to remove plugs from a 2004 Crown Victoria?

No, just remove the coil, and use a spark plug socket.


How do you fix the hazard light switch on a 97 Crown Victoria?

Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.


How do you remove water pump for 1987 ford Crown Victoria?

Remove the rad. cover, belt, fan, and there's the water pump.