Should be 'slip on' type retained only by wheelnuts and the brake caliper. Jack up the front end and support safely on blocks or stands. Then remove the wheels. Now remove the brake calipers (usually 2 7mm hex key bolts per caliper) and hang them up with wire. Do not let calipers hang by the brake hose! Also do not allow the brakes to be applied without the rotor between the brake pads! Now the rotor should slide right off the hub. Installation is same steps in reverse.
replace front brake rotors and pads.
Yes, it is 7mm allen head.
Hello, Once you take the tires off and remove the calipers, the rotors come right off just like a front wheel drive car. There is no castle nuts or bearings to deal with like the older trucks had. Good luck .............
Rotors on the front drums on the rear.
They are free floating rotors , Remove the caliper and the rotors should pull off. If not they may be gaulded on and you will need to use a hammer to help them off
how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd
you have to remove trans.after trans is removed remove tork.conv.check bushing in front pump you will find that it is bad
First remove the right and left tires, and then proceed to remove the rotors. After you have replaced the rotors put them back on.
Remove caliper, pull rotor off hub, push new one on.
pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.
howdo you change the front axel of a dodge Dakota 2000 4x4
all you need to do is pull hard. if that doesnt work tap the back with a hammer