You do not need to remove the fuel rail to remove the spark plugs.
Have to remove the fuel rail's to get to them.
On the fuel rail.
Remove the fuel rail with injectors then separate the injectors. Check related link below:
It's on the end of the fuel rail near where the fuel lines attach.
# Relieve the sytsem fuel pressure # Disconnect the negative battery cable # Disconnect the vacuum hose from the fuel pressure regulator # Disconnect the main injector harness electrical connector and the injector connectors.Detach the wiring harness retainers from the fuel rail and set the harness aside.Apply a numbered tag to each connector with the number of the cylinder # Remove the two bolts that attach the fuel pressure line flange to the fuel rail and disconnect the pressure line from the fuel rail # Loosen the hose clamp and disconnect the fuel return hose from the fuel return line # Clean and debris from around the injectors.Remove the fuel rail mounting bolts.Gently rock the fuel rail and injectors to loosen.Remove the fuel rail and fuel injectors as an assembly.Remove the fuel rail insulators.Inspect the insulators for cracks.If the insulators are cracked replace them # Remove the retaining clip and remove the injectors from the fuel rail assembly # Remove and discard all the old o-rings and seals and replace with new ones
On the frame rail underneath the rear passenger side door.
no they are not in the way at all but the air box intake needs to be removed to get to the left side spark plugs
It's on the fuel rail on the engine
They have coil packs so there is not a plug wire to follow, they are above the valve cover right beside the fuel injectors under the coil packs. The coil packs are round and black and the size of a silver dollar. Also you will have to take off the fuel rail to get to them. 2nd answer The fuel rail does not have to be removed. Just remove the connector and the one bolt from the coil and remove coil from the plug well. The fuel rail is not in the way.
bullnose pliers to remove the clip, and remove the fuel rail, replace the O-rings on the injectors, and press them into the intake, then the rail, then replace everything you had to remove
Remove the fuel rail