You take it to a certified Jaguar service center and put them to work. I would if I trusted them.
Remove your glove compartment. Look to the right side inside. Look for 2 screws, remove 2 screws. Lift up on wires, unplug wires from resistor. Plug in new resistor into wires. Screw the screws back in, reinstall glove compartment.
The short answer is: * remove vacuum lines * remove plug wires * detach throttle cables from linkage * remove spark plugs * remove 4 large hex nuts * remove washer/seals found beneatch hex nuts * remove valve cover
locate starter, mark and remove wires, remove bolts, remove starter
Remove the door panel
on valve cover just remove wires
There are two straps holding the tank on. These must be removed. The rubber that holds the filler tube on must also be removed. Be careful to not break the wires that feed the pump or the vent lines.
the trim piece that covers the inside of the door pillar must be removed. once removed you will find a electrical connector that will release the wires for the whole door, then unbolt hinges and remove
Possible problems: 1.Check the firing order of your ignition wires. 2.There could be a water inside of one of the spark plug socket,remove the spark plug and insert a clean dry cloth inside to dry-up the water.
You can't, You must remove the fuel tank to get to the fuel pump. The pump is inside of the tank.
To replace the passenger side mirror on the 1998 Nissan Maxima SE, first remove the door panel inside the door by releasing the clips below the panel and by unscrewing the handle screws. Then, remove the trim panel that covers the mirror mount inside the vehicle. There should be at least 4 screws. Release the wires from the old mirror and take the part off of the car. Add the new mirror and connect the wires. Replace the screws and the door panel.
Remove plastic air duct from under passenger side dash, and you will see a white ceramic rectangular resistor with a couple wires sticking out on the firewall by the blower motor cover. Remove screws on the resistor and remove wires to replace.
Inside the distributor - remove the cap and you will see it.