A wirebrush drill bit will work as a last resort. It is very tedious, very messy, and very time consuming - but it gets the job done.
ANSWER:There is a product called grout release which you should be able to find at Home Depot. Slate should always be sealed before you grout to avoid this problem, but very few salespeople warn you about this.
I think the wire brush drill bit may scratch the stone. Might want to try a scrub-buster first after you soak the area with grout release to soften up the grout bits. Have someone go behind you to power vac up the bits so they don't reattach to the stone. When you are done seal the stone with a professional stone sealer.
honestly, you cant.. I had the same problem, went too fast and grout dried on. I had done some 1st time tiling in other tiles, and not done slate before. Once it's dried you knackered. you can try grout residue remover(brick acid), but it will ruin anything it runs down on. better to bite the bullet, knock em off and start again...
Well YA! That is how you do it!! :)
Use a high-quality sealant and its specifications depending upon the requirement would be the best solution for the slate tile before grout.
form_title= Tile Grout form_header= Give your home a face lift with new tile grout! Do you want to install new grout?*= () Yes () No () Not Sure Do you want to clean out old grout?*= () Yes () No () Not Sure What color do you want the grout?*= _ [50] How old is the grout in your home? *= _ [50]
by adding acetone to it
No, the grout allows for tile expansion and contractions, without it your tile could crack but there are some tile that can be installed with minimal (1/16inch) grout lines.
To re-grout you mosaic tables, simply use tile grout. Be sure to remove the excess grout from the mosaic tiles to preserve the tables beautiful look.
With grout
It depends on the type of tile you have. If the tile is unglazed and porous (as mostly all travertine is) then you will need to seal the tile before you grout it so that the grout does not soak into the tile and cause it to become dull. Follow the manufacturers recommendation for the tile that you have.
It depends on the type of tile you have. If the tile is unglazed and porous (as mostly all travertine is) then you will need to seal the tile before you grout it so that the grout does not soak into the tile and cause it to become dull. Follow the manufacturers recommendation for the tile that you have.
You remove oil based paint on tile floors by using a strong detergent mixed with water and a soft cloth
You risk having the loose tile cause the grout to chip out. Find a way to secure the tile first.
Finazzle Tile & Grout Cleaner has not been discontinued. It is still available for purchase.