0
What else can I help you with?
How do you replace rear brake lights on a 1998 Ford Ranger?
There are two screws on the outside of the tail light assembly. Remove these two screws (keep them) and the assembly should be able to be removed from the truck. Carefully twist the socket out of the tail light assembly. Pull the old light bulb out of the socket and replace with new. Insert the tail light assembly into position in the truck bed and replace the two screws.
How do you remove a 1998 infiniti I30 tail light?
To remove the tail light from a 1998 Infiniti I30, first, open the trunk and locate the tail light assembly. Remove the screws or bolts securing the tail light, typically found near the trunk's edge. Gently pull the tail light assembly out, disconnect the wiring harness by pressing the release tab, and then remove the assembly completely. Finally, replace the bulb if needed before reinstalling the assembly.
How do you Remove hub assembly 1998 3500 Chevy truck?
To remove the hub assembly on a 1998 Chevy 3500 truck, first, safely lift and support the vehicle. Remove the wheel and tire, then disconnect the brake caliper and rotor. Next, unfasten the hub assembly by removing the bolts securing it to the steering knuckle and disconnect any electrical connectors if equipped with ABS. Finally, pull the hub assembly off the spindle, ensuring you have removed any retaining clips or components as necessary.
1998 Chevrolet C1500 truck how do you replace the head light lens assembly?
Remove plastic grill.(screws on top,snaps at bottom)Now you can easily see the 4 bolts that attach each light housing.Remove lights, reverse order to replace.
How do you remove the headlight assembly on 1998 Lincoln Town Car?
there are 3 pull tabs on each light housing. lift up and remove all 3 and simply pull out the complete assembly very easy
How do you remove the tail light assembly on a 98 mercury villager?
To remove the tail light assembly on a 1998 Mercury Villager, first, open the rear door and locate the screws securing the tail light. Remove these screws using a suitable screwdriver, then gently pull the tail light assembly away from the vehicle. Disconnect the wiring harness by pressing the release tab and pulling it apart. Finally, carefully take out the assembly and replace or service it as needed.
How do you replace the brake light bulb on a 1998 Chevy silverado?
when you put the tailgate down there will be two screws to remove the light assembly. then to open the light assembly it requires a 1/4" nut driver I believe? good luck its easy
How do you remove the headlight assembly located on a 1998 Cadillac cts?
There is no 1998 CTS
How do you remove dashboard 1998 s-10?
I would recomend purchsing a shop manual for that truck. It would give you step by step directions to remove the dash assembly. It will be a time consuming job. Good luck.
Where is the gas filter on a 1998 dodge 2500 truck?
Fuel filter is in the fuel tank under the fuel pump. You have to drop the tank and remove the pump assembly to change the filter.
How do you get the fan assembly off to replace a water pump on a 1998 Chevy truck?
Remove the 4 nuts that are against the pulley behind the fan with the belt still on the truck. Once these nuts are removed, the fan will separate from the pulley. Now you can remove the belt & water pump pulley.
How do you change the tail light on a 1998 Chevrolet truck?
Open the tailgate and undo the retaining screws on the side of the brake light assembly. Then trun the bulb holder counter clockwise and take the bulb out. chiefy98clg@yahoo.com
