Very easy. Takes about 3 minutes. Raise the hood. Raise the headlight manually by turning the black knob behind headlight. Headlight assembly is on an L shaped bracket. Side toward radiator has 2 bolts. Back side toward fender has 3 nuts. Remove these and disconnect wiring connecter laying on fender. And carefully lift out whole assembly.
On a 1999 C5 corvette manually put the flip up headlight in the up position, remove the plastic headlight trim around the headlight with three screws... put your bare arm under the raised headlight and remove the turn signal bulb with a careful twist.
Remove the fuse.
There is another great diagram over at Smokinvette.com in the C5 technical section! Good luck!
It is a tough job that is for sure! Take a look over at Smokinvette.com and get a full diagram of how exactly to do it! Good luck!
On the C4 the motor is actually attached to the bracket that holds the headlight assembly. There are about six 10mm bolts that hold it on and one at the end of the drive shaft. That shaft bolt is like a 5/8s and is difficult to reach. I removed the entire assembly from the hood which made it easier to get at the bolts. It's not a difficult task to remove the headlight motor. 88 and newer C4s have a different motor, but the removal process is similar. The C5 is similar as well. Hope this helps.
why does my C5 corvette idle poorly ,just for a few seconds when coming to a stop?
yes
1997-2004
You can remove your serpentine belt by loosening the tensioner pulley. Pushed the tensioner pulley to the right and the serpentine belt can be easily removed.
I have one. Thanks for asking.
C stands for Corvette, 5 stands for 5th generation.
Yes it will, to get the details on the swap feel free to drop by Smokinvette.com and just ask the question in the C5 section! Good luck!