check out the following web site: http://www.saturnfans.com/forums/showthread.php?t=92569 if the link does not work, search the saturnfans.com website for the link. We just replaced one and are hoping it works. We are in the timing-cycle phase of the replacement as I type this.
how to change a ignition switch on a nissan altima 2003
how to remove and replace broken antenna on a 2003 Saturn ion
remove 2003 Saturn vue radio
How do i unlock my ignition switch on 2003 dodge neon sometime it does it some times it doesn't but now it wouldn't unlock
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
remove trim around switch ( it just pops off ) then remove the hold down bolts, push in at an angle a bit then pull it out. but unhook battery negative cable first ! then remove the connector for the wires.
No, not any of the Saturn ION's manufactured by GM have chip keys, regardless of the model year.
You can get the ignition switch dash cover for the 2003 Monte Carlo at places like Auto Zone. You can also find this item online at AutoSport Catalog or on Ebay.
It is controlled by the ignition switch. Other than that I am unfamiliar with what you might be referring to.
lollolol
The knob you pull out is attached to the switch. To get the switch out, you will have to remove the panel underneath the dash, and some of the HVAC ductwork that runs underneath. Disconnect the battery. On the back of the switch, under the dash, there will be a little button you will have to push in to get the switch's shaft & knob to release from the switch. After that is done, you will be able to pull off the trim going around the face of the dash. It should just snap on. Then there will be a nut holding the switch to the dash. Remove the nut, the switch will come out the back, and then you can unplug it. Replace in reverse of these directions, only leave the swith shaft/knob for last. It will just push back into the new switch.
No, it does not have a fuel pump inertia switch.