Want this question answered?
Drop the fuel tank or remove the bed.
Drain cooling system Remove 4? bolts that hold fan in place Loosen and remove fan and fan belt Remove Pulley Disconnect water hoses upper, lower and bypass unbolt water pump and remove Clean mounting surface completely Install new gasket and pump Reverse to install
Drain Radiator Remove 4 bolts that hold fan in place Remove belts Remove fan Disconnect water hoses (upper and Lower) Disconnect bypass hose Un bolt Remove Clean mounting surface well--prior to insatlling new pump and gasket
Keep your owner's manual handy throughout repair. Remove spark plug wires from plugs, and place the outboard in forward gear. Loosen the shift shaft lock nut and unscrew the coupler nut, making sure to mark the original location. Tilt outboard to the up position, and remove the bolts attaching the gearcase to the exhaust housing. Remove the gearcase from the exhaust housing and secure it upright in a bench vise. If there is corrosion or the outboard has been used in salt water, you may have to use some force to loosen the mating surfaces, gently tap the anti-ventilation place down using a soft faced hammer. Disassemble the water pumpt, and remove from the driveshaft, carefully noting the order of the parts. Use a water pump repair kits rather than just replacing the impeller. Replace all seals and gaskets, lower wear plate, pump housing insert and impeller. Use all the parts that came in the kit. Before assembling the pump, grease the housing and impeller, and grease the spines on the drive shaft. Assembly is the reverse. Install the gearcase on the exhaust housing. Make sure that the water tube lines up with the pump outlet. if the drive shaft and crankshaft splines do not line up, turn the propeller slightly to aid in alignment. Test the outboard for good water flow.
The filter is on the carburetor ,the fuel line from the fuel pump connects to it. Remove the fuel line , using a wrench on the filter as well to keep it from turning , then remove the filter (steel) from the carburetor .
Chances are, if it is fuel injected, it is in the gas tank, and you will have to empty and drop the tank to get inside. After you drop the tank, it should be self explanatory.
underneath panel on passenger side . remove the lower side bottom panel and you cant miss it
How to remove calipers on 2005 Ford F-150
Yes, the fuel pump is inside of the gas tank in a Ford F-150.
How do you remove a front rotor on a 1993 F 150 4X4
Yes , on a 1990 Ford F-150 , there is a fuel pump inside each fuel tank
the fuel pump is inside fuel thank.