Pop out the window control button first. Then there are two plugs behind the interior door handle that need to be removed. Then using a Torx (T-25) screw driver remove two screws behind where the pugs were. You need to go upward at a slight angle to contact the screws. Once they have been removed (they may fall down inside the door but will be able to be recovered when the door panel is removed) begin at the bottom of the door and spring out the door panel going in both directions around towards the top. Then the entire panel can be lifted up and removed. Take care to allow the door operating handle to slide out from its position in the panel.
Read "How do you remove the interior door panel on a 2000 Pontiac Grand Am?" the answers are prettymuch perfect
just remove it
How do you remove the drivers door panel and fix the window. It fell off the track.
You have to remove door panel
Under the dash, left side you will have to remove the close out panel.
Using a screwdriver, remove all the screws in the door panel and remove all the clips holding the panel to the frame. Gently pull the panel away from the frame, remove an wire connectors and pull the panel off the frame.
Ihave 2000 grand prix how to remove dash board to remove radio Go to http://www.carstereohelp.com/stereoremovalPontiacGrandPrixSt2.htm
Fuel pump is located in the trunk on the left side you have to remove the interior panel
how do remove a 1999 ford mustang interior door panel
How do you remove the interior rear door panel on a 2004 isuzu ascender?
This should help http://documents.victorytechnologies.com//documents/product/1392.pdf
Check out this website*** http://www.a1electric.com/grandam.htm *** It shows how to remove the panels on a 2002 model. It might be similar.