well first get two tools. steering wheel puller and a lock plate "c"clip tool. remove steering wheel, lock plate and remove the three screws that hold the turn signal switch in place remove turn signal handle and 4 way button. pull the turn switch out of the way, there is enough cable to do so. the key switch is held in place by a small flat retainer about a 3/8 inch long. if you have a new unit in hand you can gauge where the release slot is. depress the retainer with a screw driver blade and slide out the old one and slip in the new. enjoy
I assume this question is about the mechaincal part of the keyswitch. Remove the plastic cover under the steering column and keyswitch. Turn the ignition key to run (not start). Underneath the keyswitch, there is a small round hole. Push something like a paperclip in the hole and the ignition keyswitch will pull right out. If this question is about the electrical switch part of the keyswitch, there is a single Phillips screw holding the switch in place, just remove the screw to remove the keyswitch. www.driftmotion.com
how do you remove the doors from a 2004 jeep wrangler
You have to remove the driveshaft to flat tow a 2wd Jeep.You have to remove the driveshaft to flat tow a 2wd Jeep.
It's probably a faulty keyswitch.
You can't
It's probably the keyswitch sensor that detects the key.
undo the bolts from the side and remove top. its not hard
remove Allen screws in the vents pull the covers and remove the deck
unbolt it =]
No.No.
No
Jack up the jeep, place a jack stand under the axle, loosen and remove the lug nuts and pull the wheel off.