0
I recently purchased a new 2009 Malibu. Because it appeared that a special tool is needed to unscrew the three fasteners, I requested the dealer to have their bodyshop remove the license plate bracket. The bodyshop apparently had to drill the fasteners out.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove front license plate bracket 2009 Mercury Mariner?
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
How do you remove the front license plate bracket on a 2002 Volvo s40?
Hit a Large tree or pole
How do you put a license plate holder on a 2004 Chevy Malibu?
take off the license plate then screw the holder on with the plate.
Front license plate mounting Chrysler Sebring convertible?
There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
Is there a license plate light on a 2000 Chevy Malibu?
yes there is, just above rear plate.
How do you install the front license plate bracket on a Honda Pilot?
The Honda Pilot does not come with pre-drilled holes for a front license plate bracket so first you have to drill the holes. Once the holes are drilled then you can use the screws that came with the bracket to secure it into place.
Can the front license plate be in the windsheld?
Probably not. That's why you have a bracket in your front bumper.
How do you move a travel trailer you are purchasing from Michigan to Florida if it has no license plate?
You put a sign in the license bracket "in transit"
Replace license plate bulb for BMW 525i?
Turns out, the directions are in the user's manual! But, since I didn't look there, and to save others from having to look it up, here's how to do it (for a 2004 525i):Insert a screwdriver or key into the slot in the license plate bulb bracket and slide the bracket to the right until the left edge drops out of its latched positionThen, with your fingers you should be able to slide the bracket to the left to release the right edge of the bracket My license plate frame obstructed the right edge of the bracket a little, so I had to remove the left screw attaching it to the car, and screwed it back in after the bulb bracket was reinstalledWith a slight wiggle, the bracket should drop all the way down, allowing you to easily get to the bulb and replace itReverse the steps to replace the bracket
How do you remove a license plate?
You unscrew it!
Remove front license plate cover on a 1990 corvette?
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
What is best way to remove on a GMC CAYON THE LICENSE PLATE LAMP?
HOW IS BEST WAY TO REMOVE BULB ON THE GMC CANYON FOR LICENSE PLATE LAMP ?
