Want this question answered?
Have to remove the doorliner from the rear door. Remove the 2 screws that hold the black trim that covers the lamps. Then you can remove the clear cover and access the lamp.
secondary backup lamps Remove secondary backup lite retaining nuts. Remove secondary backup lite assembly. Push secondary backup lite assembly outward from rear fascia. Remove the socket. Twist socket and pull outward. Remove the bulb. Twist the bulb and pull outward. License plate lamps Remove the license lamp retaining screws. Remove the socket. Remove the bulb.
I now know! The back lights on the lower 'skirt' are covered by a plate. To remove - remove the three small bolts holding the mud-flap and plate and remove the plate. Access can now be gained to the back of the light cluster. Lamp holders are removed by turning anti-clockwise. Rusty bolts are your only problem!
I do bleave thet is under the back seat(just remove the seat and there is a plate there for the fuel pump) I think it is ther But I may be rong.
The lamps are spring loaded on one side. Push the lamp towards the center and remove. Put in bulb and snap back in.
I finaly found out how to replace these license plate lamps. I open the trunck, removed all the 15 screw that retain the big brown plastic panel. Then remove the panel and remove the center stop light (3 mores screw). Finaly, remove directly the bulb housing by the rear by unscrewing them with the hand. And remove the bulb from the housing.
to find your registration number you have to remove your left rear tire and it will be etched in the hole where your tire was.
rear tail light fuse
Remove the rear seat...You'll see the sending unit with the connectors(it's a metal plate)...Remove all the screws,unplug the connectors and hoses and the whole sending unit comes out in one piece....It's very easy//
Remove the rear seat bottom. There is a plate with roughly 6 screws. Remove this plate and there will be another plate on top of the fuel tank. Unplug the wire connector and remove the screws and lift out the plate with the fuel pump attached. Remove the fuel pump from the plate.
yOU WOULD NOT IT IS ILLEGAL TO HAVE A NON LIGHTED TAG
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.