0
Take the oil filter off and remove the threaded piece that the oil filter screws onto with a #10 allen wrench, it will fit up inside of the center. Then with I believe a #40 torks remove the two bolts that holds the adapter to the block, once the adapter is removed, screw the center threaded piece that you first removed into the block and install a new oil filter. Then you can remove the oil lines from the radiator.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the oil sending unit located on the 2001 Chevy 4.3 vortec engine?
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
How can you tell if the oil pump on a 2002 Chevy Impala 43 liter V-6 has stoppedmworking?
Low or no oil pressure.
Where is iat sensor on 43 Chevy?
there isn't one.
What is code 43 1992 Chevy S10 blazer?
knock sensor
What is the spark plug gap for a 2005 Chevy cavalier?
.43 is the gap
What is the bolt pattern for a 2000 Chevy Malibu wheel?
5x115 43 offset
How do you replace starter 1996 buick regal?
1995-96 VEHICLESSee Figure 13Disconnect the negative battery cable.Remove the upper mounting bracket above the radiator.Detach the electrical connections at the coolant fan, then remove the fan.Disconnect the upper and lower oil cooler pipes from the radiator.Raise and safely support the vehicle.Unfasten the retainers from the engine harness and position them away from the starter.Disconnect both lower oil cooler hoses from the radiator.Detach the starter electrical connections.Remove the upper flywheel inspection cover.Unfasten the mounting bolts/screws, then remove the starter and shims (if used) from the engine.Fig. Fig. 13: Starter motor mounting-1996 3.8L engine shownTo install:Position the starter and shims (if used) to the engine, then secure with the mounting bolts/screws. Tighten to 32 ft. lbs. (43 Nm).Attach the electrical connections to the starter. Tighten the solenoid battery terminal outside nut to 12 ft. lbs. (16 Nm). and the solenoid "S'' terminal inside nut to 22 inch lbs. (2.5 Nm).Position the upper inspection cover, then secure with the retainers to 89 inch lbs. (10 Nm).Attach both lower oil cooler hoses to the radiator.Fasten the engine wire harness and retainers.Carefully lower the vehicle.Attach the oil cooler pipes to the radiator.Install the coolant fan and attach the electrical connectors.Install the upper engine mounting bracket and tighten the bolt/screws to 32 ft. lbs. (43 Nm).Connect the negative battery cable, then check the engine oil level and add as necessary.Information comes from autozone.com
How much weight do you save with aluminum heads on a small block Chevy?
About 43 Lbs.
What is spark plug gap for 2004 Chevy vortec 4200?
43 thousands of an inch
How much oil pollution is caused by humans?
43% of the oil pollution taht happens is caused by humans.
What is the 5 bolt hole pattern for a 1992 Chevy pickup?
4 x 43/4
How do you adjust the idle on a 95 Chevy Blazer 43 liter V6?
it is not adjustable, it is controlled by the computer.
