You cant, you have to remove the section of piping and install a new section of piping.
Yes, sometimes enough heat to melt parts of plastic piping.
Could be a floating ground. Measure between "earth" and Hot. For earth find a copper pipe that is grounded to earth or a cast iron drain pipe.
you should see a doctor....
Goes down a pipe, out of the house to a bigger pipe that takes it to a waste treatment plant that removes all the solid parts and filters the water and then puts the water into a stream or river.
There is Black Iron pipe, made of iron. There is Cast Iron pipe, which is black in colour, made from old cars and their parts. There is black ABS plastic pipe, made of plastic. There is Utility pipe, also made from plastic.
Mission CAP or IPS plug if there is a female fitting
Remove the bottom hose to drain the system. Remove the top one as well and flush from the top with a brisk flow from a hose pipe.
The toilet flange is usually above the floor level. You would have to cut it off the drain pipe and cap it. How you do this depends on what type of pipe the drain is made of. Even if the drain should be below the floor level, you have to seal the drain or sewer gas will come up from the drain.
There should be a nut around the chrome pipe holding it to the brass. Loosen the nut and pull the chrome pipe out.
Radio Shack "drain pipe tracer".
If it's a sink drain , best to remove the entire pipe and P trap. I then take outside and hose them out.
Drain enough of the radiator to remove the top radiator hose. Remove the hose, then the pipe that the hose connects to. The bottom end of the pipe houses the thermostat.
with a pair of channel locks or a pipe wrench
Foul Air
Yes, a sewage drain pipe can be too large.
If you are talking about a roof water drain pipe to sewer it is illegal. If you are talking about a sink drain pipe well that is where they all connect to so yea.
dvw pipe = drain, waste and vent pipe.