jack up vehicle, keeping jacks in front of axle, so you can roll it out the back. remove brake lines parking brake cable, diff and hub breathers, if they are attached to anything other than the axle, remove springs and shocks. double check to make sure nothing is attached to axle, and then roll it straight back. too easy if you are mechanically inclined, if not, go to a professional.
how do you remove the right rear axle on a 1998 ford expedition?
how to remove rear axle from 1988 f250 ford
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Above the rear axle on the drivers side. Remove the left rear tire to help gain access to it.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
98 accord does not have a rear axle- just spindle/hub/bearing
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.
The best way to remove the rear axle on a Polaris Hawkeye is to spray it with PB blaster. After waiting several hours or a day, simply pull the axle outward.Ê
It is on top of the rear axle.
Remove wheel, Remove drum or disc brake rotor,remove rear differental cover. Remove shaft between the spider gears that is held in by a lock bolt. Shove the axle from the outside toward the differential and remove the "C" clips that hold the axle in inside the diff. and then the axle can be removed.
Remove the tire and wheel from your 2003 GMC 2500 Sierra. Remove the end of the axle. Using a seal puller remove the axle seal. Reverse the process to install your new rear axle seal.