Jack up the rear of the car so that the tires are barely touching the ground.
Place jack stands under the frame. remove jack.
Disconnect ebrake, brake lines, driveshaft, shocks, lower and upper control arms. Might take a little force to get springs out of seats.
Axle is now separate from vehicle.
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
Disassembly
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
You have to take the differential cover off and remove a C clip that holds the axle shaft. that will allow you to pull out the axle (****** note the number of splines on the axle if ordering part!!!!)
One of them is 112 inches from axle to axle. The other one is 120 inches from axle to axle.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
Jack the car up, loosen the bolts and remove the wheel. The next thing is to loosen the nuts joining the axle to the stath then remove the axle.
how to remove, or replace front right axle escape 2004
Like 3 .42
Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.
It's bolted to the bottom of the car above the rear axle (forward of the gas tank). If you're going to remove it, relieve the pressure by pulling the fuse for the fuel pump and running the car until it runs out of fuel.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.