0
There should be a strap at the rear bottom base of the seats. Pull this strap and tip forward. The seats will lift out.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is ignition switch for 2000 Oldsmobile silhouette?
Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?
Anything bad about a 2000 Oldsmobile Silhouette?
No
How do you change an alternator in a 2000 olds silhouette?
Remove the alternator belt on your 2000 Oldsmobile. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Put the new alternator on and reverse the process.
What is the fuel tank capacity for 2000 Oldsmobile Silhouette van?
25 gallons
Can you install and amp in a 2000 Oldsmobile silhouette?
if you need mean an amp for a stereo ? yes you can
How do you reset the message center on a 2000 Oldsmobile silhouette?
all the messages are showing up on my 2000 olds silhoutte, why does it do this
Will a 2000 Oldsmobile silhouette driver information center fit in a 1998 silhouette?
1998, 1999, 2000 are interchangeable as well as the same parts from a Venture and a Montana. Same thing, different vehicle.
How many oxygen sensors are there in a 2000 Oldsmobile Silhouette?
There are actually two oxygen sensors on a 2000 Oldsmobile Silhouette. There is one located in the exhaust system just before the catalytic converter. There is also another oxygen sensor in the air intake tube leading from the air filter.
Where is the thermostat located on a 2000 Oldsmobile Silhouette?
Follow the top radiator hose down to the engine. It is in the water outlet.
Where is the low side port on a 2000 Oldsmobile silhouette?
it is on the passenger side at the front under the hood next to radiator
Where is the fuel shut off in a 2000 Oldsmobile Silhouette?
GM vehicles are not equipped with a fuel pump inertia switch.
Remove motor from driver door on a 2002 Oldsmobile silhouette?
I'm not sure if they changed anything between 2000 and 2002, but my 2000 window motor has 3 VERY breakable plastic clips that holds the motor in place around the gearbox.
