answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove sinotec TV lock key without remote?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to remove TV lock?

my tv has child lock on without a remote how do i fix this? also my tv wont turn on at all.


How do you turn the child lock of on daewoo tv without remote controler?

how to turn off child-lock without remote daewoo DL-32C3


How do you replace tailgate door handle on 1997 ford escort wagon?

Remove the tailgate trim panel. Disconnect the remote control rod from the remote control. Disconnect the negative battery terminal. Unbolt the latch and remove the remote control. Disconnect the lock knob rod from the remote control and remove the rod. Disconnect the lock cylinder rod from the lock cylinder. Unbolt the remote control and remove it from the liftgate. Remove 2 nuts that hold the outside handle and take it out of the liftgate. Installation is the reverse of the removal steps.


How do you open the trunk on a 2005 Buick LaCrosse without the remote?

press the door lock open or lock for 5 seconds.


Can any wheel dealership remove a wheel without whell lock key?

Yes, a good mechanic should have the tools to remove a wheel lock without damage to the wheel.


My remote does not lock my 97 Ford Expedition?

my remote only unlocks and does not lock what should i do?


How do you remove a lock cylinder from a 1972 Chevelle without the key?

you don't.


Replaced battery in remote now red light comes on remote and car central locking and alarm goes on is it remote or fault in remote?

I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .


How do you remove ignition lock key without key?

Removing a ignition lock cylinder from a 2002 ford windstar with no key


Why won't my remote lock or unlock my doors?

have you checked to batteries in the remote?


How do you remove the ignition switch on a 1971 Chevy blazer without a key?

You would have to drill out the center of the lock or have a locksmith pick the lock.


How do you prograre your 2005 Honda Pilot key?

Get in car, close the door, make sure all doors are closed, DO NOT LOCK THE DOORS .... Put the key in the ignition, turn the key to on but without starting the car (lights on dash light up only) press and release the key lock button on the key remote in the ignition, turn key to off, without removing the key...... Turn to on without starting the car (dash lights up only) press and release the same key remote lock button again, turn the ignition off, without removing the key...... Then turn back on (lights on dash on only without starting the car, press and release the same key remote lock button again, turn off the ignition without removing the key.... Turn on the ignition once more without starting the car, press and release the same key remote lock button again and you should hear the door lock click (the locks will not cycle -- just a slight click) ....leave the key in the ignition ... Now within 3 seconds, press the lock button on all other remotes you want to program (one at a time)..... you will hear a slight lock click for each remote indicating the remotes are being programmed.... Now remove the key from the ignition and you can test the other remotes. (THEY WILL NOT WORK WITH A KEY IN THE IGNITION) You should be able to lock and unlock the doors with each new remote. The sequence of turning the key in the ignition on and off is only required with one key. (Usually one you already have programmed) That is all there is to it. It works like a charm and saves you money. My dealer wanted 1 hour shop time to program it ($65).