You just put one edge of the bracket and pull it off
remove the steering knuckle, put it in a vise and if there are no snap rings inside the axle opening, get a big hammer and go at it.
Insert the tip of your snap ring pliers into the two tiny holes on the left and right hand side of the snap ring. Then press the snap ring pliers together fairly hard and pull out the snap ring. Note: Make sure you have snap ring pliers because snap rings are very tool specific.
Remove the tail housing. Remove the snap rings on the output shaft. Remove the small snap ring on the weight side of the govenor. Slide the valve and pin out the oposite side. Remove the 4 bolts that hold the governor to the governor support. Slide the governor off the output shaft.
You have to pull the bearing assembly out. Be careful and do not let the cap covering the bearings come off.
Since it's very difficult to get to the clamps underneath the hood, I recommend working from inside the car. Remove the cover from underneath the center of the dash.Remove the bolt holding the heater-core tubes, which are attached with snap rings.Remove the snap rings.Grease the "o" rings in the tubes before reassembling.Replace the heater core.Replace the snap rings and cover.Drain and replace the coolant bleed system.
The snap rings that hold the shifter in place have popped out and you will need to remove the boot to put everything back where it belongs.
jnbh
butter
Remove the six bolts, pull cap, remove snap ring. Snap ring could be covered by grease.
Remove shift release button off the top of the shifter, inside there is a small snap ring. Remove the snap ring and lift the shifter knob off.
You will need to have both snap rings removed and the rest of the locking hub should just pull out easily. You could also try using a 4 pronged socket if you have spindle lock nuts.
are they wind up windows or power windows? for power windows remove the door panel screws and pull. for wind up windows remove small metal snap rings behind the window handle. remove them and then remove all door panel screws and pull door panel off.