0
go to auto zone.com enter vehicle info.then look up starter,then click on repair guide and it will tell you.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you take out a starter on a 1988 Nissan pickup with a v6 engine?
remove neg.cable.then positive cable cable from starter,remove male to female wire ,then remove 2 bolts holding starter to engine.
How do you replace starter on 1988 Chevy 1500 pickup?
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
How do you change the starter on a 1988 Nissan pickup?
disconnect neg. battery cable ,remove pos.cable from starter .10 or 12 mm wrench.remove wire from starter ,no wrench needed,its a male to female connector,remove 2 bolts holding starter to engine,12 or 14 mm wrench,thats it.
How do you replace the starter on a 1988 Chevy pickup 8 cylinder?
Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
Can you swap the engine from a 1988 Nissan pickup to a 1984 Nissan pickup?
no 84 and 85 swap out.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
Where is the starter located on a 1988 Nissan Stanza?
The starter on a 1988 Nissan Stanza can be found on the inner side of the engine. It is between the gear box and the engine block.
Where is the starter on a 1988 Nissan Maximum?
On the bottom of the transmission one nut one bolt make sure you remove the battery cable.
Will a 1988 Nissan pickup transmission fit a 1987?
no they changed in 88.
What is the fuel pressure for a 1988 Nissan Pickup V6?
36.5 psi
How much engine oil is needed for a 1988 Nissan pickup?
4.5 qts.
How do you replace a starter on a 1988 Chevy astro van?
Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
