how do i replace the bendix drive in my 85 harley fxrs
Remove the starter. the solenoid is mounted on the starter.
you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.
Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.
You buy a service manual and study it very carefully. It's worth it, cost is about $30.
the bendix gear on the starter is stuck on the flywheel remove starter check bendix gear for wear if worn to bad replace starter
simply put, buy a repair manual; you are going to need it. Be prepared to remove the primary cover.
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
If the starter spins but won't engage, then the Bendix is not engaging the flywheel. Remove the starter and test to see if the Bendix thrusts out, and check to see that the flywheel does not have chipped teeth.
REMOVE OUTER PRIMARY COVER. REMOVE JACKSHAFT NUT( THE SMALL NUT ON THE SMALL GEAR TOP REAR) TWO SCREWS(BOLTS) THAT RUN INWARD THRU STARTER BELOW OIL TANK REMOVE STARTER FROM BACK OF INNER PRIMARY. IF YOU BUY A HARLEY DAVIDSON SERVICE MANUAL, THE PROCEDURE SHOULD BE THE SAME AS HARLEY'S. LAKELIZARD
In my harley devidson its immobilizer lock could you told me how to unlock
how do you remove the back wheel on a 2005 Harley Davidson Dyna low rider FXDL