I ran across the following one day, don't know the source so can't give credit due:
The rod on which the sun visor is mounted has an internal tab that must be aligned with a slot in order to withdraw it. Kind of hard to find the alignment but for starters:
Loosen the screw at on the sun visor face near the ball end of the rod. Orient the visor in the down position to approximately match the angle of the ball end of the rod. Wiggle and pull along the rod until the tab and slot find themselves and the visor starts to move along the rod. You will be able to withdraw it enough to slip the new clip on then push it back in place.
What about the sun visor...the answer didn't say anything about how to remove and replace the visor
Remove the sun visor retaining screws. The sun visor will slide off of the sun visor rod. Lubricate the sun visor rod. Put the sun visor back on.
how do you remove a sun visor on a 2001 buick regal
How to remove the sun visor on a 2002 VW passat driver side
You have to remove the sun visor using a sharp blade to separate the visor itself from the adhesive. After you need to remove the adhesive using organic solvent such as ethanol, acetone and so on. Then you can install new adhesive tape, and reinstall the sun visor. Or you can install a new one.
remove two screws on each side of visor. pop out visor. then pop out shield. reverse to reinstall.
You can remove the sun visor on your Toyota Rav4 by removing the screws on the swivel arm. When they screws are remove the visor should come off.
the only repair is to replace the visor as an assembly.There are no serviceable parts inside it
How do you remove 1998 Buick regal ls sun visor
Call Nissan Consumer Affairs... 1-800-647-7261 This has been a problem they have had with the visor. If your visor will not stay up... this will impair your view while driving. Ask if they will please replace your visor for free and they will!
== ==
There are five steps on how to replace the vanity visor mirrors in a 1993 Mercury Tracer wagon. Some of the step-by-step instructions are unscrew the visor fasteners and lower the visor, and then make sure to use the pocket screwdriver to unclip the wiring harness from the visor.