Want this question answered?
i need a diagram to show me how to remove a starter on millenia s 1999 mazda
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
You will need a power steering pulley puller. It is designed to remove and install the power steering pulley. If you attempt to remove the pulley without it you will probably damage the pulley or the pump or both.
Remove the belt(s) and manipulate the pulley by hand; its action should be butter-smooth.
There are a couple of ways. Changing the pulley size to a smaller supercharger pulley will increase the speed of the supercharger, giving you more boost. You can also go with a larger crank pulley and it will do the same thing. Please keep in mind that when you do this you are adding more air into the engine so you will need to add more fuel. Getting it tuned afterwards will be a great idea. You can also do a thing called "S Porting." This is basically porting out the supercharger and slightly modifing it so that the air flows smoother. Also you can just get it custom tuned. By putting your car on a dyno and having them adjust the air/fuel mixture and timing curves it will result in better performance and more HP Thank you, From www.SuperchargersOnline.com
With a power steering pulley puller. Your local auto parts store should have one you can rent or buy.
The 2005 SRT6 crossfire had a supercharger, would need to get injectors, programmer/chipand atleast a pulley to low the boost to a safe level, but would be the best bet. Not too many aftermarket ones avail. due to the low production #'s.
The millenia P - has 2.5 liter engine, The Millenia S has a 2.3 liter engine
Looking at the fan from the front you would turn it counter clock wise to remove it. You will probably need to hold the pulley from turning also.
There was no replacement for the Millenia. Too bad as it makes me keep my now 11 year old Millenia S.
how does the belts go on a 1996 Mazda millenia
The bolt, nut and washer they give you with a replacement p/s pump is only for installing the pulley. To remove the pulley from the old pump without damaging the pulley requires a special puller. Many auto parts stores can rent you the proper puller for the job.