Remove the taillight assembly to gain access to the bulbs
How do you remove taillight cover on a T-100 toyota Truck
Open the rear hatch. you will see 2 screws on the side of the taillight. Remove them and pull the taillight out.
Open the liftgate Remove the 2 screws at the top of the taillight assembly Carefully " work " the taillight straight back towards you . There are plastic pins shaped >>>>>>>>>>>> that hold the taillight assembly in place The bulb sockets are a simple turn to remove / install
From the inside.
tip lemon juice on it innit
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
Taillight bulb replacment/Taillight housing replacement * Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
To remove the shift knob on a '95 Mazda MX-3 just twist the knob itself counter clockwise until it comes off!
The entire taillight comes off as an assembly, and is not designed to be taken apart. To change a light bulb: 1. Inside the trunk look on the back side of the taillight near the quarter panel. There will be 3 nuts, the center nut holds the taillight assembly in place, remove that nut. 2. Pull the assembly rearward enough to bring the stud out from the header panel, then pull the tab out of the license plate light assembly. 3. Remove the socket that needs a new bulb and replace the bulb, then slide the taillight assembly back in place and put the nut back on.
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
Remove bedliner( if applicable). You must remove the taillight framing to get to bulbs. There are two screws located behind the taillight, that must be unscrewed to loosen the taillight frame from the truck body. Remove the two screws via the truckbed side and framing will loosen and bulbs can be replaced.