0
How do you remove the PVC valve on a 98 Chrysler tc with 3.8l engine?
Wiki User
∙ 12y ago
It is located on the rear valve cover to the rear of the alternator
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can you remove a 1991 Buick 38L engine without also removing the transaxle?
Not very easily if at all, and why would you want to?
Where is the oil pump located in a 89 Pontiac Boneville SSE 38L Engine?
on the crank behind the front cover
Ca a 38L engine in a 1994 Chrysler Town and Country Van be replaced with a 33L engine from a later model year?
Well, the transmissions are interchangable, so your good there. But if you put a 3.3l in youll have to change the ECM because they have different settings for the 3.8 and 3.3. So if you change the ECM I think youll be ok. My email is RPplayer73@aol.com
How much horsepower does a 38l V6 Firebird have?
If you mean 3.8 Litre engine, the answer is 200 horsepower, from the factory. 225 lb/ft of torque.
Why is your 96 Pontiac fire bird 38L suddenly making lots of valve noise at start up like an engine with no oil but goes away and sounds runs fine after warm up any ideas Oil pressure is fine?
It seems it may have been bad gas. After some gas treatment and an oil change it gradually improved in three or four days and then stopped completly.
Where can information on timing marks and how to align them on a 1995 Ford Mustang V6 38L engine be found?
haynes repair manuals are good but you can go to autozone.com and they have online repair manuels as well it a good site for a lot of information on repair work.
Where is the thermostat in a 1997 Grand Prix SE 38L?
The 3.8 engine is similar in all the grand prix 97 to 2003 Follow the top radiator hose to the top of the engine, the place it bolts up to should be your themostat. Remove the hose, take the bolts out (usually two) put the new one in with a new gasket and bolt it back together. For thermostat replacement step by step instructions with pics- http://www.pfyc.com/supportfiles/tstat/tstat.htm Hope this helps. "G"
You can't reach the hoses behind the engine when trying to replace the bypass tube on a 1999 windstar 38L?
Remove the cowl assembly. It is easy here is how: Remove the wiper arms and remove the 4 little plastic push pins along the drip rail edge under the hood that hold the plastic cowl cover on. If there is an antenna, unscrew that from the base and pop the cowl cover off. Then remove the 5/16ths screws that hold the cowl pan/wiper motor assembly to the vehicle(I believe there are 10 of them). Lift the cowl pan off while paying attention to unplug the wiper motor connector on the driver's side. You will have to steer it out past the hood hinges. Now you have as much room as you need to do anything you want to behind the engine.
Trying to locate the IAT sensor on a 1991 Mercury Cougar 38L?
it's located on the firewall right in back of the intake
Where is the air sensor on a 91 Buick Regal 38L located?
The mass air flow sensor is located in the throttle body housing on the 3800 engine. There should be 4 screws that hold it down to the housing. Once they screws are removed, the sensor lifts off of the throttle body.
Where can you find step-by-step instruction on removal and installation of the power steering pump reservoir in a 1994 Mustang 38L?
A haynes manual...
How many gallons is 38liters?
3.8 litres is fractionally more than 1 US gallon.
