0
Disconnect the negative battery cable.
- Raise and safely support the vehicle.
- Remove the right-hand halfshaft (axle)
- From the rear of the alternator, depress the lock tabs on the wiring terminals and pull the terminals straight off. Mark the location of the wires prior to removal so they can be reinstalled in their original positions.
- Loosen the alternator adjustment and through bolts to allow the alternator to pivot. Remove the alternator drive belt.
- Remove the alternator adjustment bracket, lock bolt and through bolt.
- Hold the alternator to prevent it from falling and remove it through the space left from the removed halfshaft.
To install:
- Position the alternator and loosely install the mounting and adjustment bolts.
- Install the drive belt and adjust the tension Tighten the through bolt to 27-38 ft. lbs. (37-52 Nm) and the adjusting bolt to 14-19 ft. lbs. (19-25 Nm).
- Connect the wiring terminals at the rear of the alternator.
- Install the right-hand halfshaft.
- Lower the vehicle. Connect the negative battery cable.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the voltage regulator in a Ford Probe?
In the alternator. Have to replace the Alternator.
How do you by pass the alarm on a 1990 Ford Probe?
The nosiey engine in ford 1990 how can we overcome it?
1990 Ford Probe distributor?
What is your question?
How do you replace an alternator on a 89 Ford Probe?
I had this problem what you need to do is remove the half shaft to get this out because there is no room to get it past this point. Sorry for the bad news.
How do you remove alternator ford escape 4 cylinder?
How to remove alternator on 2001 ford escape 4 cylinder
How do you replace the alternator on a 1996 Ford Probe?
I have a 97 Ford probe and when I had to replace my alternator... I had to pulled the passenger tire off and pull the whole assembly apart so I could get the alternator.. There are 2 bolts to loosen up and pull the belt out slide the alternator down by the exhaust and pull it out by the CV axle
Does anything need to be taken off to remove a starter on 1989 ford probe?
does anything need to be taken off to remove a started on 89 ford probe
How do you replace the alternator on a 1990 Ford Probe GL?
Remove belt tentioner bolt and belt (from top), and support bolt (from bottom). Remove driver wheet and unbolt sway bar, replace wheel. Remove passenger wheel and support vehicle. Remove sway bar bolt, sway bar can now swing up and down. Remove lower splash cover. Remove alternator from opening in fender well while pushing down on sway bar. Replace in reverse order.
How do you remove the alternator from a 96 KJ Ford Laser?
You have to remove the brake master cylinder and remove alternator through there.
Where is the voltage regulator on a 1995 Ford Probe?
The voltage regulator is on the alternator. It is all one piece.
Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
How do you replace an alternator on 2003 mustang gt?
Remove the alternator belt from your 2003 Ford Mustang alternator. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
