Just under the front of the bottom on each side of the seat are two small black levers that you have to push down. These will unlatch the bottom seat. They may also be covered by the leather, so you might have to push the leather back a little to get to them. Once the bottom seat is out, you can take the back cushion out. Do this by removing the bolts where the seat belts attach to the floor using a 12 mm scoket. They may be covered by a leather flap. Then you can push it up and out.
Push back on the bottom of the bench seat (takes a lot of pressure) to release holding clips Lift bench out Back of seat is secured by clips or bolts that are now accessible - remove these and lift upward on back of seat to release upper clips Remove seat back
Fuel pump Mazda 626The way I did it was remove the back seat and there is a panel under the lining, unclip wires and loosen bolts!
Remove the four bolts on the bottom of the seat back and the 2 bolts on each headrest. Take out the headrests. Lift straight up.
Look under the front of the back seat, you will see 2 large bolts. Remove those and the seat bottom will pull straight out. Now you will see 2 bolts under the seat back, remove those, then lift up the seat back and it should come free. That's it.
* Remove the seat cushion by pulling out on the retainer then pull up sharply on the cushion.After removing the cushion remove the bolts and lift the seat back out
the fuel pump is in the gas tank itself. You have to remove the back seat to get at it.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
1993 kawasaki voyager motorcycle how do you remove the driver seat?
Push on the lower end of the seat to unclip holders (takes a lot of pressure) After unclipped slide forward to remove bench You will then see clips or bolts holding the back of the seat remove/release these and slide back up to release upper clips
at the bottom of the back of that seat their should be latches you push down to release!
there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.