Want this question answered?
sounds like you broke the crank sensor that is mounted right behind the balancer.
yes that bolt is keep the balencer mounted to the crank shaft
how to remove crankshaft position sensor from 91 Buick Regal
Very Carefully
You must remove the fuel tank.
Labor is no more than about 1.5 Hour. So depending on the shops hourly labor cost.
The Crank sensor in my 91 LeSarre Limited is behind the Harmonic balancer pulley....there are fins on the back of the pulley that line up with the sensor.
yes
Where is the MAF in 91 Buick century
It is under the harmonic balancer, the large pulley on the end of the crank shaft. To remove, jack up the right front of the car. Remove the tire. Remove the plastic splash shield. Remove the serpentine belt before you jack the car. Use an air impact wrench to remove the large bolt in the end of the crank. Use a puller to remove the balancer. DO NOT try to pry the balancer off. Metal fins on the back side and you will destroy them. The crank sensor is now visible and can be easily removed. Mark the old sensor's position and install the new one in the exact same position. It has room for adjustment. It has to line up perfectly with the metal fins on the back side of the balancer. If you don't have an air impact wrench, better borrow one. No good way to keep the engine from turning using a socket and pull bar.
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
If they are the exact same engine (3800 tuned port injection) then yes.