Want this question answered?
on the bottom passenger side under the glove box remove the cover, locate the blower motor, disconnect the plug from it, remove 3 screws and the blower motor should come out.
Begin by removing the wiring harness from the back of your blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
It is in the top left firewall. There are 4 screws to remove, and the blower motor will be attached to the cover of the firewall. Paula
Blower motor resistors are usually located close to the blower motor.
Blower motor resistors are usually located close to the blower motor.
how do i change my blower motor on my 2007 malibu
on the motor.
If the Heater/AC blower motor has stopped operating on one of the setting, then the problem is not in the switch but in the blower motor resitor. This item has several coiled wires and is housed behind the blower motor just in from of the firewall. If the motor stopped working all together it could be a bad switch on the head unit. 1. Remove the coolant recovery/winshield washer resivoir. 2. Disconnect the electrical connector at the blower motor and the vent hose. Disconnect the cruise control servo (if equipped) and set it aside. 3. Remove the 4 screws holding the blower motor and remove the motor. 4: The resitor is exposed. Remove the bolts holding the resitor. 4. To install the new one, just follow the steps 4-1 backwards. 1991 through 1994 access the switch through the ash tray. Remove and replace 1995 through 2007 access the switch through the radio. Remove the radio by using to removal clips, or unbolt the bezel from the two bolts then slide then entire bezel out. Replace the switch.
how d you remove the blender door motor on a 2007 impala
Most likely a bad blower motor resistor assembly. Go to dealer to see if it can be covered under warrenty.
Take down the glove compartment. You'll see it.
The blower motor resistor on my 2007 Chev. Colorado is located on the passenger's side, under the dash, behind the glove box. You don't need to remove the glove box, just lay on the floorboard and look up under the dash. There's a 4-wire harness plugged into the resistor assy (white plastic), in the bottom of the black heater blower shroud. Unplug the harness, remove two small screws, and pull down to remove the resistor assy.