Want this question answered?
Answer 2002 Neon, 6 screws. Unscrew 1 ea. screw from each cupholder. Open center cosole and unscrew remaining 4 screws. Emergency brake ALL the way up. Lifting from the rear and pushing forward lift out the center console.
It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 Phillips head screws
Step 1: Open the glove boxStep 2: Remove the "carbon fiber" strip starting under the glove box (it's just clipped in)Step 3: Unplug battery so you don't harm anything electronicallyStep 4: Remove the two screws at the left and right of the displayStep 5: Put fingers in square spaces next to where the bolts where and pull...Step 6: Done. Repeat steps backwards to reassemble
Excerpt from shop manual.Removing and Installing Cover at Gearshift Lever-1. Remove plastic frame upward(Picture shows the trim piece around the shifter.)-2. Remove covering in stowage compartmentNote: Fastened with pin(Picture shows stowage compartment in front of shifter.)-3. Remove center console insertNote: Remove screws (2 each) from insert floor(Picture Shows compartment under console armrest being removed.)-4. Press cover out of catch in center console ~ at rear and sides with long wedge(Pry up console cover at rear edge that was exposed by removing compartment.)-5. Disconnect connectors from center console switch group-6. Install in the reverse order
2001 Toyota Sequoia: Accessing the Center Console to remove/replace the JBL amplifier powering the rear speakers. The bolts you'll have to remove have 10mm heads. Locate a crescent wrench, a long extension if you have one, and a 10mm socket. A flat blade screwdriver may be helpful in removing the wiring harness plugs, I just used my finger nails. 1. Remove the shifter knob on the center console 4WD shifter (assuming you have a 4WD model). 2. Grab the center rib of the console tray (the tray under the shifter) and lift straight up. The black tray with leather shifter boot popped up and out quickly easily without prying. 3. Next you'll need to remove four (4) 10mm black bolts to lift up the center console to get to the amplifier installed underneath. 4. Remove two bolts at the rear of the opening under the tray just removed, at the front of the center console. 5. Open the center storage and pop out the plastic CD organizer tray from the bottom of the center console storage area. 6. Remove two 10mm bolts in the bottom/rear of the section. 7. With these four bolts removed, grab the front of the center console section and lift up and back, the center console will pop apart from the front console skirt. 8. To improve access and tilt the console back higher, remove the wire bundle clip right under front of the console (probably AC controls). 9. The JBL amplifier is held down by two gold colored 10mm bolts, remove those. 10. There are two wire bundle connected to the amplifier, squeeze the tabs on the white wire bundle connectors to remove them. 11. Remove the JBL amplifier. Twenty minutes elapsed time. 12. Reverse these steps to bolt everything back up. I'll post pictures at www.tundrasolutions.com when I replace the amplifier.
626
remove door panel, remove speeker.
To remove the air box on a 2007 Mazda 6, remove the nuts on the top of the box. Carefully place the nuts aside, and remove the top to access the filter or housing assembly.
big truck and a chain
hammer and strength
There are screws going through the bottom into the floor, should be about 6 in the front, middle, and back of the inside of the console.
what is an air box