0
if your talking about what fell in side the cylinder ? first bring the cylinder up top do this by hand not to cause damage to cylinder wall or head than take a 3 prong grabber place a well chewed piece of gum on it put it in spark plug hole and spin it slowly around the cylinder . make sure not to open the grabber when in the cylinder dropping the gum
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Remove a rock stuck next to your spark plug?
Buy a cheap ice pick. Using a vise or good pliers, bend it at the end at a 90 degree angle or so to make a hook. It should be strong enough to get the rock out. Otherwise pull the spark plug boot off, break the ceramic plug part, remove all broken fragments of rock and ceramic, then unscrew the rest of the broken plug and install a new plug.
How do you remove a broken spark plug from Dodge Grand Caravan?
With great difficulty. If you can get the ceramic part out of the plug, you need an easy-out and a torch. Heat the plug with the torch, then use the easy out to get the plug out. If that doesn't work, you'll have to pull the head and take it to a machinist.
Which part of a spark plug is make of corn?
The insulators which are made of ceramic uses corn in the production of said ceramic. Amazing
What tools would one use to get a spark plug that is broken off on the engine?
It depends on where the plug is broken off.If just the ceramic part is broken you can just attach the socket to the lug and remove it normally.If the nut is broken and the rest is lodged in the hole you would use an ez-out.It threads into the remaining piece counterclockwise and when it bites into the remaining piece,it will thread it out of the block.Alot of auto parts stores have tools they will lend you to do this or you can buy an ez-out big enough to handle the job.
Your key broke off in the ignition of your 1991 Toyota celica how to remove ignition to remove broken part?
Flush the lock with a lubricant. Use the handle of the broken key as a guide. Find a thin wire and stiff it along the sides of the broken key part. Hold the wire in place and remove the part.
What is the name of that rubber thing under ignition coil and around ceramic part of spark plug in Grand Vitara V6?
The spark plug boot? yeah sum say coil wire , but its actually the coil to spark plug boot. KongKit
How do you repair handleset thumb latch?
You remove it from the door and find exactly which part is broken,replace that part.
HOW TO Remove a rusted broken off piece of metal from inside plastic part?
A magnet
How do you fix a 1988 Buick Century Limited that has a broken off spark plug still in the head?
Even if the sparkplug is broken, you should be able to get a socket on it and pull it loose. Once you've turned out the metal part it should be rattling around and you should be able to remove the plug. If it's hard to reach, try a magnet.
How do you remove a broken spark plug from a 6 liter vortec 2002 gm sierra 2500?
Keeping the plug wire out of the way, Start the engine. In a few minutes the engine pressure should push out the porcelain center from the plug. At this point you can use a tool called an easy out to remove the threaded part of the plug.
You broke a plug trying to remove it what is the best way to get it out?
Usually if you break a plug it is only the top white ceramic part. The only time this would be a problem is if your plugs are in the top of the head and down in a hole. They do make needle nose pliers long enough to reach down and get the plug. The ceramic part should have come out with the socket if using a regular spark plug socket. That would leave just the base. Take the socket and put a piece of tape on the inside of the socket on each face. Bring it out over the edge of the socket and onto the outside. This will make the socket enough smaller that it should hold on to the base of the spark plug so you can get it out.
How do you find out if my riding mower is not getting a spark?
take the spark wire off, remove spark plug, put wire back on plug, put steel part of plug against the medal part of engine (with a insulated pare of pliers) then crank the motor over watch the electrode on end of plug if you see spark you have it if you don't ....
