Want this question answered?
Remove bolts on the underside of lid at the hinge. Remove screws on bottom side of the lid. Gently pry bottom of the lid from the top of the lid, there's a metal bracket in between them. The console lid should then be apart from the console.
You have a two year old hang on it until it breaks off, that's why I am looking for a replacement lid.
Pry out the gear selector trim with a screwdriver and lift it out.Open the console lid and remove the screws on the bottom.Remove the screws on both sides of the console.Lift the console up and over the shift lever.Disconnect any electrical connections and remove the console from vehicle.
If you are talking about the arm rest lid, you have to remove the screws at the hinge. If you are talking about the base, it is part of the console and requires more work.
Yes, it is all one piece. Remove the rubber bumpers under the lid, remove the screws and compartment liner; remove the 2 screws under the liner; remove the shifter bezel by pulling up; remove the 2 screws that hold the front of the console to the dash; pull up on the emergency brake handle as high as you can, then pull the console back and raise the rear of console and pull up to clear the emergency brake handle.
Unbolt the entire console, something fell down in the front of the front console lid. then turn it over and whatever is jamming it should fall out.
You start under the console lid, removing the two screws at the front of the storage bin, working your way forward to the next panel.
Remove 2 screws from the back holding the top lid, then slide the lid backwards and lift the lid.
if it is loose under the console storage, it is probably the bracket under the storage bin. Remove the two screws holding the lid and the two screws by the latch hole and the two screws on the bottom to remove the inside of the storage area. Once you get it out you might see that the bracket that the screws on the bottom of the storage bin go into is broken. You can get a replacement bracket for about $80.00. You have to remove the console to replace.
1. Open cup holders and remove (2) Phillips 7mm screws. 2. Unsnap and remove dual power outlet assembly from lower storage. 3. Open lower storage door and remove (2) 7mm screws inside. 4. Models with DVD - Remove DVD player and remove (2) 7 mm screws from behind and (2) 7 mm screws near the floor. 5. Remove lower storage compartment . 6. Remove (2) 7mm screws (facing up) from under cup holder.
in center console under lid
I had the same problem. Here's how I fixed it; you take off the cup holder assembly directly in front of the console lid by wedging a screwdriver on both sides and squeezing it with your other hand. This should unsnap it. Then the console lid and the cup holder should lift up together. Underneath you can see the latch where the console lid attaches to the cup holder assembly. I sprayed some WD-40 on the latch spring assembly and it pop free. Then you just snap back the cup holder which is now unlatched from the console lid. Thoroughly lubricate the latch spring assembly and it should work better.