answersLogoWhite

0


Best Answer

Instrument Cluster Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the cluster opening trim panel. 3. On vehicles equipped with an automatic transmission, remove the loop on the indicator cable assembly from the retainer pin. Remove the thumbwheel bracket screw from the cable bracket and slide the bracket out of the slot in the steering column tube. 4. Remove the instrumental cluster retaining bolts. 5. Pull the instrumental cluster out of the instrument panel. 6. Detach the electrical connectors. 7. Remove the instrument cluster. To install; 8. The installation is the reverse of the removal. 9. Connect the battery cable, and check the operation of all gauges, lights and signals. *** Turn the light bulb housing counter clock wise. Sometimes they are very hard to turn. Don't be afraid to turn them. ***

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the dash board on a 1998 Ford Expedition Eddie Bauer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you get the message center to work on a 2003 Ford Expedition Eddie Bauer?

what does it mean when this appear on the message board " timing 99:59:59: "?


2002 Ford Explorer Eddie Bauer dash board lights?

Need to know what about the dash board lights.


2003 Eddie Bauer expedition What makes your side mirrors go way out of limits and begin clicking then not return to set position like they should with the reverse assist?

This is a common problem. A firmware (software) update is available from Ford to help correct this problem with the mirrors on the 2003 Ford Expedition Eddie Bauer going out of limit, clicking, and not returning to the previous set position after the reverse assist. You can also disable the reverse assist from the computer dash board control.


Where are the door switches located on a 1999 Ford Expedition Eddie Bauer?

The door switches are located inside the door locks. If your having any problems with them. for example your interior lights / running board lights exc, are staying on . spray some WD-40 on all the door jams including the rear door hatch and glass. this should take care of problem.


Your 98 Eddie Bauer Expedition has running board lights that don't work All other lights do work There is a relay that controls the running board lights. Where is this relay located?

under the hood on the driver side there is a fuse box at the very rear if u don't look hard u will miss it cause it is small but u will see one fuse box there but look a little further back to see the other fuse box


Where on a 1994 ford explorer Eddie Bauer is the reset switch for the fuel pump?

I believe that is in the right front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump


If the check engine light is on and running lean whats wrong on with the 98 Eddie Bauer expedition?

This issue very well could be caused by a bad O2 sensor. The sensor is getting a bad reading and making the incorrect fuel mixture. This vehicle has OBD2 or on board diagnostics, and you can take your vehicle to some auto parts stores and have them use a device to get the diagnostic code. This should be able to help with your troubleshooting.


Fuel pump switch location 1994 Ford Explorer Eddie Bauer?

I believe the fuel pump inertia switch is in the right front passenger footwell , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump


How much would a vintage Bauer wooden banana board with cement wheels be worth?

$1,000,000


Where is the inertia switch located in a 1991 Ford Explorer Eddie Bauer?

I'm not a mechanic / technician but check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump . I believe that is where the inertia switch was on my 1993 Ford Explorer


How do you remove the light bulb from the light bulb assembly when replacing the running board light on a 1997 Expedition?

If I recall correctly. It should be a peanut light bulb. And if it is a peanut bulb they just pull straight out.


Where can I get a sticker for my car saying ' I am an Eddie Stobart spotter' from?

i would like to no where i can get an eddie stobart spotter on board car sticker please find it from louis graham the top eddie fan