If I recall correctly. It should be a peanut light bulb. And if it is a peanut bulb they just pull straight out.
What causes the generator to burn out after replacing the alternator
sort of you can remove the fuel pump assembly (its in-tank)the clean of the mesh screen best you can do
Remove the headlight assembly to gain access to the bulbs.
look in the users manual for the instructions on replacing bulbs. it's the same because you have to remove the assembly to replace the bulbs there are 2 jack screws , on the top of the assembly, one on each side. remove them and pull the assembly out towards the front of the car. remove the lights put the lights in the new assembly. put the new assembly back in and replace the jack screws. you will need to adjust the lights.
If I remember correctly it will be located at the bottom of the windshield under the cowl assembly and you will need to remove the wiper arms and the cowl to remove this............
Open the hood, remove the pins holding the headlamp assembly, remove headlamp assembly, now you can reach in and remove the day time bulb socket assembly to replace the bulb. Repeat procedure on other side.
Remove the headlight assembly to gain access to the bulbs.
Replacing the turn signal switch involves replacing the entire turn signal assembly. Remove the screws from the steering column cover to remove the top of the steering column. You can take off the bottom (I was able to work around it). There are only a few screws holding the turn signal assembly. Remove the screws and unfasten the electrical connectors.
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.
If it is 4x4 remove axle from wheel bearing assembly and then remove the wheel bearing assembly. Make sure the tone ring (looks like a ring with teeth) is still attached to the spped sensor side of the bearing, if not, replace wheel bearing assembly with an assembly that comes with the speed sensor. Replacing a speed sensor without a tone ring is pointless because it won't work.
how do you remove the grill from a 2008 ford expedition?
You will have to drop the fuel tank. Remove the pump assembly. The new pump should have instructions for replacing the unit.